Liberty Installation




Click here to download a pdf of the No Drop Posi-LockĀ® instructions.

Click here to download a pdf of the installation instructions.

Follow these simple instructions to install our Liberty telescoping flagpole.


Tools and materials needed for concrete base install:


In-ground sleeve mount


  1. Select a clear flag and flagpole location (above and below ground). Check for underground sprinkler, water lines, electrical lines (call utilities if needed).
  2. Dig a 25" hole with a tapered diameter, see diagram below.
  3. Put a 3" of gravel under base of aluminum sleeve (allows for drainage).
  4. Place the plastic cap in the top of the aluminum sleeve (keeps the cement out).
  5. Place aluminum sleeve into hole with plastic cap on top (2" sleeve should be above ground level).
  6. Mix bag of concrete and pour into hole.
  7. Temporarily hold aluminum sleeve vertical fill in the hole with concrete to 1" below ground level.

print this page


Contact Us


You can call us at 1-888-454-9164 or click here to e-mail your comments or questions to us.